Delmhorst Instrument RDM-3P - Manual (Page 13)

Copyright  2005, Delmhorst Instrument Co.
Page 10 of 28
o T° (Temperature Compensation)
o JOB (current job)
o ALARM (current alarm setting)
o MODE (current measurement mode)
o EXIT (leave MC READ Mode)
NOTE: The default selection on this screen is MC reading, which places the
meter in measurement mode. Pressing the SELECT key causes a single reading
to be taken (Triggered mode) or initiates a reading stream (Continuous mode).
READ MODE – CONTINUOUS/TRIGGERED
The meter has two measurement modes: Triggered and Continuous. Choosing
the MODE option and pressing the SELECT key will change the measurement
mode.
o Triggered mode causes a single reading to be taken every time the
SELECT button is pressed. Each reading is stored in memory. The last
measurement remains displayed on the screen.
o Continuous mode starts by pressing the SELECT key. The meter keeps
taking MC readings in this mode. These readings are NOT stored until the
SELECT key is pressed again. To exit continuous mode WITHOUT
STORING the current reading, press any directional key (UP, DOWN,
RIGHT, LEFT). To exit continuous mode and STORE the current reading,
press the SELECT key. Exiting continuous mode leaves the last reading
on the screen. To resume continuous mode, press the SELECT key again.
Use the directional keys to choose a different option.
TEMPERATURE COMPENSATION
o T
° : This menu option selects the Temperature Compensation screen: