COSA Xentaur Hygrocontrol Type 83 - Manual (Page 2)

HYGROCONTROL Manual for Type 83 Page - 1 -
TABLE OF CONTENTS:
1. Fundamental Features of Series 83 2
2. Preparations before operating 2
2.1. Unpacking and Checking 2
2.2. Set-up for Operation 2
2.3. Instructions for Dispatch 3
3. Technical Data 3
4. HART 4
5. Operation 4
5.1 Mode "MEASUREMENT" 5
5.2 Mode "CALIBRATION" 5
5.2.1 General Notes concerning Calibration 5
5.2.2 How often Calibrations should be done 5
5.2.3 Calibration Chamber 6
5.2.4 Mounting the Calibration Device 6
5.2.5 Operation via BUS Commands 7
5.2.6 List of possible Commands 8
5.2.7 Output Examples 8
5.2.8 List of used Abbreviations 9
6. Practical Instructions and Limits 10
6.1 Direct Contact with Liquids 10
6.2 Filters 10
6.2.1 Resistance against high Air Velocities 10
6.2.2 Resistance against Dust and Aerosols 10
6.3 Resistance against Chemical Attack 11
6.4 Protection of Transmitter Electronics 11
6.5 Influence of Temperature on Humidity 11
6.6 Humidity Measurements over Ice 11
6.7 Measurements under Pressure and Vacuum 12