Catskill Craftsmen 51538 - Manual (Page 10)

STEP 9
A. Stick magnet to magnet plate on an outside door.
B. With adjacent door open, close the outside door. The magnet should be positioned over the
wooden block on the bottom of the top front brace. Hold the magnet in place with your thumb, and
open the door. The magnet will be in the correct position on the block. Mark the position with a pencil.
C. Secure magnet with the two round head screws in the magnet packet. Center screws in the slot in
the magnet . This will allow adjustment later, if needed.
D. Repeat these steps for all the doors.
STEP 10
A. Insert and tap caster sock-
ets with hammer until the teeth
grab the wood. DON’T POUND
SOCKET FLAT OR CASTER
SHAFT WILL NOT ENTER.
B. Insert casters and seat by
pushing straight downward
with heel of your hand, or tap
into place with a hammer. Don’t
be afraid to give them a good
downward whack on the solid
metal part of the caster!
C. Locking wheels usually
go on front.
Magnet (4)
5/8” Pan Head Screw
8 Used
in this step
No pilot holes
as soft wood.