Catskill Craftsmen 51533 - Manual (Page 9)

STEP 12
A. Attach the drawer back to the drawer side with two
1 1/2” #8 screws. The drawer back leave a 1” gap at the
top to allow drop leaf support clearance. Make sure parts
are aligned as in illustration 12A.
B. Insert drawer bottom into the slots in the drawer sides,
best side to inside of drawer. Slide down until seated in
the slot in the drawer back. See illustration 12B.
C. Screw the cam posts into the two outside holes on
the inside face of the drawer front until seated. Only
3/8” of this post goes into the wood, leaving the 4 larger
guide rings/head exposed. See illustration 12C. Visit our
website www.catskillcraftsmen.com for a video on cams.
D. Insert the posts into holes in the drawer side until
seated against the front ends of the drawer sides. Insert
cams so that slot in the cam fits over the post and turn
with Phillips screwdriver until seated. Don’t over-torque!!
See Illustration 12D. See our video online at
www.catskillcraftsmen.com
E. Attach drawer handle with the two 7/8” Truss Head
screws (no illustration.)
F.Attach drawer glides to drawer sides using 5/8”
#5 screws. See illustration 12E. Drawer glides are flush
with front of the drawer sides.
ILLUSTRATION 12A
ILLUSTRATION 12B
ILLUSTRATION 12D
ILLUSTRATION 12E
ILLUSTRATION 12C
Below line in wood
Cam Posts (2)
2 used
in this step
1 1/2” Phillips Flat Head #8 Screw
2 used
in this step
7/8” Truss Head Machine Screw
2 used
in this step
Cam
4 used
in this step
5/8” Phillips Flat Head #5 Screw