Catskill Craftsmen 51533 - Manual (Page 4)

STEP 1
A. Decide which side to put the towel bar on. Attach a Glide Support Stick to the top of each Side
Panel using 1 1/4” #8 screws. The countersunk holes (reamed out) in the stick are positioned as
in illustration 1 so that the glide holes are toward the lower edge. Sticks should be flush with top of
panel.
B. Attach the cabinet glide of the Drawer Glides to the Glide Support Stick using 5/8” #7 flat head
screws. Left glide to left Side Panel, right glide to right Side Panel. The glides look almost alike
however, the right glide (as you face the cart) has a rolled lip at the top of the glide that keeps the
drawer glide wheel in place. Line up the holes in the glides so that the end with the wheel comes flush
with the front edge of the Table Top Stick.
C. Attach the “L” brackets to the top of the glide supports using 5/8” #7 screws. Use the slot, the side
with the hole is used to attach the table top. The top of the “L” Bracket should be even with the top
edge of the glide support stick.
Note: Glides are marked right/left with imprint behind wheel.
TOP TOP
5/8” #7 Screw
1 1/4” #8 Screw
5/8” #7 Screw