Catskill Craftsmen 51533 - Manual (Page 8)

STEP 10
Install Doors/Bottom Front Brace
A. Install doors by inserting pins in the door tops into the holes in the top front brace.
B. Place one washer on each of the door pins
in the door bottoms.
C. Take the bottom front brace, align pins
in door bottoms with holes along
top edge of brace
(are washers on pins??)
and secure brace with
1 3/4” bolts/hex nuts as before.
STEP 11
Attach Magnet to Magnet Block
A. Stick magnet to magnet plate on right door.
B. With left door open, close the right door. The magnet should be positioned over the wooden block
on the bottom of the top front brace. Hold the magnet in place with your thumb, and open the right
door. The magnet will be in the correct position on the block. Mark with a pencil.
C. Secure magnet with the two pan head screws
in the magnet packet. Center screws in the slot in
the magnet. This will allow adjustment later,
if needed.
1 3/4” Phillips Flat Head Bolt
2 Used in this step
10-24 Hex Nut
2 Used
in this step
2 Used
in this step
3/16” Flat Washer
Magnet
5/8” Pan Head Screw
2 Used
in this step
Magnet
5/8” Pan Head Screw
2 Used
in this step
Magnet
5/8” Pan Head Screw
2 Used
in this step