Catskill Craftsmen 51533 - Manual (Page 5)

STEP 2
A. Lay back panel flat on a smooth surface with holes up.
B. Attach both side panels (glide wheels go toward front
of cart) with 1 3/4” bolts and hex nuts. After inserting bolts
through the holes in the side panels, through the holes in
the long edges of the back panel, place a hex nut on the
tip of your finger, align nut with bolt and tighten.
C. Look ahead to step 5 which shows side panels
attached to back panel. Glide wheels toward the front.
Note: Make sure you position the side panels according
to drawer side left or right.
Not used
if present
STEP 3
STEPS 3-13 WILL BE ACCOMPLISHED WITH THE UNIT
TOP UPSIDE DOWN (INVERTED), BUILDING UPWARD
TOWARD THE BOTTOM/CASTER END! BE CAREFUL AS
PART DESCRIPTIONS ARE BASED ON AN
UPRIGHT, COMPLETED UNIT!
Assemble top by placing the top and the drop
leaf upside down on a smooth flat surface.
Install hinges using 5/8 #8 screws. The
longer part of the hinge goes on the
drop leaf with the short part on the
cart top. Fasten the drop leaf
supports using 5/8 #8 screws.
5/8” Phillips Flat Head #8 Screw
20 Used in this step
STEP 4
Make a large X mark over each of the inside
pilot holes in the bottom. Make marks about 1
1/2” long. These marks will help you align the
cabinet with the inside pilot holes in step 5.
This table top is used on two different models.
The holes on the outside, without markings in
the illustration, are not used.
Side Panel Leg
Inside Brace
Countersunk Hole in Leg
( disk goes in this hole to
hide bolt head! )
Nut Access Hole
Hex Nut