Catskill Craftsmen 51533 - Manual (Page 10)

STEP 13
Install Casters
A. Insert and tap caster sockets with a
hammer until the teeth grab the wood.
DON’T POUND SOCKET FLAT OR
CASTER SHAFT WILL NOT ENTER.
B. Insert casters and seat by pushing
straight downward with the heel of your
hand, or tap into place with a hammer.
Don’t be afraid to give them a good
downward whack on the solid metal
part of the caster!
STEP 14
Install Shelves/Disks
A. Upright unit. Take bottom shelf
(no edge banding) and place it on
the set of back pins as shown. Close
doors and shelf will drop into place.
DO NOT FORCE!
B. Tap two 1” pins into each side
panel to hold middle shelf, making
sure the pins on both sides are
in the same relative position. To
remove a pin, use pliers or a claw
hammer.
C. Place middle shelf, edge banding
out, on pins.
D. Insert drawer. If drawer hits the
bottom of the cart top or the top front
brace, tap the top front brace down,
then re-tighten screws and insert
wooden disks into sides.
Edge
Banding
4 used in
this step
1” LONG 3/16” DIA. STEEL PIN