Catskill Craftsmen 51531 - Manual (Page 8)

1 3/4” Phillips Flat Head Bolt
2 Used
in this step
10-24 Hex Nut
2 Used
in this step
ILLUSTRATION 9A
Allow for 1/8” Space
1 3/4” Machine Screw
Nut
STEP 9
A. Take the top front brace (with magnet block), insert the pins in the brace ends
into the slots on the inside of the front legs and slide down until the brace rests
on the bottom of the drawer front. The pin holes for the door pins will be up.
B. Twist drawer dowel into the 1/2” dia. hole
on the inside of the brace under the
magnet block.
C. BEFORE securing brace with
1 3/4” bolts /hex nuts, raise brace
approximately 1/8” before tightening.
This will allow the drawer to
open easily when unit is
uprighted.
1 3/4” Phillips Flat Head Bolt
2 Used
in this step
10-24 Hex Nut
2 Used
in this step
ILLUSTRATION 9A
Allow for 1/8” Space
1 3/4” Machine Screw
Nut
1 3/4” Phillips Flat Head Bolt
2 Used
in this step
10-24 Hex Nut
2 Used
in this step
ILLUSTRATION 9A
Allow for 1/8” Space
1 3/4” Machine Screw
Nut