beautypg.com

Step 4, Step 5, Step 6 – Catskill Craftsmen 51531 User Manual

Page 6

background image

1 1/4” Phillips Flat Head #8 Screw

4 Used in this step

ILLUSTRATION 4

1 3/4” Phillips Flat Head Bolt

4 Used

in this step

10-24 Hex Nut

4 Used

in this step

ILLUSTRATION 5

ILLUSTRATION 6

Holes for caster wheels

1 1/4” #8 Screw

1 3/4” Bolt

Nut

Front

Back

STEP 4

Attach a table top stick to

the top of each side panel

using 1 1/4” #8 screws.

The countersunk holes

(reamed out) in the stick are

positioned as in illustration

4. Sticks should be flush

with top of panel.

STEP 5

A. Lay back panel flat on a smooth surface with holes up.
B. Attach side panels with 1 3/4” bolts and hex nuts. After

inserting bolts through the holes in the side panels and

through the holes in the long edges of the back panel, place

a hex nut on the tip of your finger, align nut with bolt and

tighten.
C. Look ahead to step 7 which shows side panels attached

to back panel.

STEP 6

STEPS 6-12 WILL BE ACCOMPLISHED WITH THE UNIT TOP

UPSIDE DOWN (INVERTED), BUILDING UPWARD TOWARD THE

BOTTOM/CASTER END! BE CAREFUL AS PART DESCRIPTIONS

ARE BASED ON AN UPRIGHT, COMPLETED UNIT!

A. Invert table top on a smooth flat surface and make a

large X mark over each of the 4 pilot holes in the bottom.

Make marks about 1 1/2” long. These marks will help

you align the cabinet with the pilot holes.

Side Panel Leg

Inside Brace

Countersunk Hole in Leg

( disk goes in this hole to

hide bolt head! )

Nut Access Hole

Hex Nut