Axxess Interface ASWC - Manual (Page 13)

13
11) Then the LED will flash, up to 11 times, depending on what radio the
ASWC thinks it’s connected to.
12) Make sure the number of flashes match what radio you have
installed. Refer to the Changing Radio Type section, pages 13-14.
13) If the LED flashes match the radio then hold down the “Volume
Down” button until the LED goes solid red.
14) Programming for the vehicle and the radio is now complete. Test out
the steering wheel control functions to make sure it works correctly.
Changing Radio Type
If the LED flashes do not match the radio you have connected, you must
manually program the ASWC to tell it what radio it is connected to.
1) To manually program the aftermarket radio, press and hold the
“Volume Down” button on the steering wheel control until the LED
goes solid red, then release “Volume Down”.
2) At this point Eclipse is programmed. If you are using an Eclipse radio
go to step 3. If you are using a different radio go to step 4.
3) Press and hold “Volume Down” for 5 seconds. The LED will flash
once then go solid red indicating the programming has finished. Go
enjoy your radio.
4) If you have a different radio then Eclipse, press the Volume Up
button again till the LED goes solid red, then release “Volume Up”.
You have now programmed Kenwood.
Section 3: Troubleshooting