WycoTool Single and Double Powerhead - Manual (Page 9)

Page 9 Form: 01-SCR-UM-00442 Rev 6/12
THROTTLE CABLE ADJUSTMENT
The throttle cable on the Screed King comes pre-
assembled for your convenience. Over time you
may notice that it takes more clicks on the throttle
to get to optimum RPM level than when you first
ran the screed. This is normal, over time your
throttle cable will stretch.
THROTTLE CABLE ADJUSTMENT
To adjust your throttle cable to compensate for this
stretching, simply locate the barrel adjuster where
the cable runs into the underside of the engine
and turn it counterclockwise with a 8 mm wrench.
Tighten the locknut to hold it in the desired posi-
tion.
ATTACHING THE SCREED BAR
Locate the threaded studs on the screed bar and
loosen the locking handles. Slide the power head
of the screed over the threaded studs. Fasten the
power head to the bar using the locking handles
and washers provided, as shown below. The
washer and lock-washer should contact the silver
handles when installing the power unit. Make sure
to tighten the bolts fully so they do not vibrate
loose during use.
ATTACHING THE SCREED BAR