WycoTool Single and Double Powerhead - Manual (Page 5)

Page 5 Form: 01-SCR-UM-00442 Rev 6/12
3. Keep hands, feet, hair and clothing away from mov-
ing parts.
4. Stay away from hot engine components during
operation.
5. Do not run screed in an explosive atmosphere or in a
poorly ventilated or enclosed area.
6. Stop engine, disconnect spark plug wire and wait for
all moving parts to stop before servicing, adjusting,
repairing or cleaning.
7. Do not smoke when refueling gas engine.
STORAGE SAFETY
1. Store unit in an area away from human activity.
2. Do not permit children to play around the stored
screed.
REFUELING SAFETY
1. Handle fuel with care. It is highly flammable.
2 This is a four cycle engine, use non-mixed gaso-
line of no less than 87 octane.
3. Allow engine to cool for 5 minutes before refueling.
Clean up spilled fuel before restarting engine.
4. Do not refuel the machine while smoking or when
near open flame or sparks.
5. Always use an approved fuel container.
6. Fill fuel tank outdoors.
7. Prevent fires by keeping machine clean of accumu-
lated trash, grease and debris.
OIL LEVEL CHECK
OIL FILLER CAP/DIPSTICK
LOWER LIMIT
OIL FILL HOLE
(bottom edge)
OIL FILLER HOLE LOCATION
It is important that the engine oil level be main-
tained at the correct level. High or low oil levels will
cause permanent damage to the engine requiring
replacement. To check the oil level:
1. Place the screed board on a flat level surface. This will
ensure that the engine is in the proper orientation to
perform an oil level check
2 Carefully unscrew the oil filler cap/dipstick and
wipe it clean.
3. Insert and remove the oil filler cap/dipstick without
screwing it into the oil reservoir neck, then remove it
to check the oil level shown on the dipstick.
4. If the oil level is near or below the lower limit mark
on the dipstick, fill the reservoir to the bottom edge
of the oil fill hole with the recommended oil (see
Honda engine owners manual). To avoid overfilling
or underfilling, be sure the engine is in a level posi-
tion as shown when adding oil
5. Reinstall the oil filler cap/dipstick and tighten se-
curely..
Notice: Running the engine with a low oil level can
cause engine damage. This type of damage is not
covered by the warranty.