WycoTool BD Pneumatic Concrete Vibrators - Manual

Wyco Pneumatic
Operator’s and Service Manual
“BD” Pneumatic Concrete Vibrators
w wy yccoo
R R R R
READ ALL SAFETY INSTRUCTIONS
3. SAFETY INFORMATION & EQUIPMENT (cont’d):
Always use approved safety equipment. The following
safety equipment applies to operators and other
personnel in the immediate vicinity of the working zone.
- Safety Helmet - Protective Gloves
- Ear Protection - Protective Shoes
- Dust mask (dusty environments) - Eye Protection
`
4. MACHINE KNOWLEDGE: Before starting the equip-
ment make yourself familiar with the machine and
make sure that the machine does not show any
obvious faults or wear. Then start the machine
according to the instructions.
5. OPERATION: Use the machine only for the purpose
for which it is intended. Make sure you know how to
stop the machine quickly in the event of an emergency
situation. Do not touch rotating parts during operation.
6. MAINTENANCE: Maintenance work must only be
carried out by a skilled operator. Keep unauthorized
people away from the machine. Do not carry out
maintenance work while the machine is moving or
while the engine is running. Never use a machine that
is damaged.
7. BE ALERT: Always concentrate on what you are doing.
Use common sense and never operate the machine if
you are tired or under the influence of drugs, alcohol or
other substances which can affect your vision, reaction
time, ability or judgement.
!
!
1. WORKING AREA: Do not operate a machine that is
powered by a gas or diesel engine in a poorly ventilated
space. These types of engines produce toxic gasses
which cause serious health problems.
2. POWER EQUIPMENT:
- Pneumatic Machine: Check that the compressed air
hose and the hose coupling are not damaged.
WARNING: Never attempt to loosen any
compressed air hose that is pressurized. First
switch off the air at the compressor and then allow the
machine to run to a stop to discharge any existing
compressed air.
- Machine Powered By Gas or Diesel Engine: Gas has
an extremely low flash point and can be explosive in
certain situations. WARNING: Keep away from all
hot or spark generating objects, do not smoke
when handling fuel. Wait until the machine has
cooled before filling the tank. Avoid spilling gas or
diesel fuel on the ground.
3. GENERAL SAFETY INFORMATION & EQUIPMENT:
The admissible sound of 85 dB (A), can be exceeded
because of the machine and/or the application. Long
time exposure to loud noise without ear protection can
cause permanent damage to hearing. Long time
exposure to vibration can cause damage to the hands
fingers and wrists. Do not use these vibrators if you are
experiencing discomfort, cramping or pain. Consult a
doctor before working again with the vibrator.
TECHNICAL DATA
Type BD 35 BD 55 BD 65 BD 75
Head Diameter in(mm) 1.42(36) 2.20(56) 2.64(67) 3.03(77)
Head Length in(mm) 10.51(267) 13.54(344) 14.37(365) 15.67(398)
Head Weight lbs(kg) 3.3(1.5) 9.9(4.5) 17.38(7.9) 19.6(8.9)
Amplitude (Total at tip) in(mm) .027(.69) .037(.94) .054(1.37) .070(1.78)
Frequency (Max at 85 psi) (v.p.m.) 17,600 17,700 17,700 17,000
Centrifugal Force (Max at 85 psi) lbs(kg) 441(200) 1484(675) 2548(1158) 3278(1490)
Air Consumption (Max at 85 psi) (cfpm) 27 54 54 85