WycoTool SELECT-Cycle Converter User Manual

Wyco, Select-cycle converter, Danger caution

SELECT-Cycle Converter

Operation Manual & Parts List

20 Amp & 30 Amp Models

SAVE THESE INSTRUCTIONS

wyco

Read, understand and follow all of these instructions before using this equipment.

HAZARDOUS VOLTAGE:

SERVICING INFORMATION:

DO NOT TOUCH.

Fincor Automation Series 5740 Manual
Wyco Tool Company (1-800-233-9926)

NOTE:

This unit is designed to produce high voltage and should be operated in a dry environment.

Never attempt to service while running. Many parts in this converter operate at line voltage.

Use only

electrically insulated tools.

This equipment should only be serviced by qualified electricians/personnel. Additional instructions are located in the

and must be read and understood before servicing this converter. Contact

if the above mentioned manual was not included with the order or you can also

go to

and download the manual. Before servicing or removing the cover, disconnect the power supply.

Wait 5 minutes before removing the cover to insure that the internal components have had time to de-energize/discharge.

Check that the power LED is

not lit. Also check that the output voltage is below 24 Volts before beginning. If the unit is subjected to an excessive shock
by being dropped or impacted, or if the enclosure is damaged, it should be disconnected and not used until it has been
inspected and repaired by qualified electricians/personnel. Check all cables, plugs, and electrical outlets to be sure that
they are not damaged before connecting equipment.

www.Fincor.net

Some components may remain energized/charged even after being unplugged.

POWER SOURCE:

ENVIRONMENT:

Choose the appropriate AC power source (230 volts, single phase, 50/60 Hz) for the input power to

this converter.

This converter should only be used in a well ventilated environment which will allow heat to dissipate.

This will prevent potentially damaging heat build up internally. Do not use in ambient temperatures greater than 105
degrees F/40 degrees C. Keep away from external heat sources.

eep the converter away from or do not place the converter on top of something that creates excessive vibration.

Death or severe injury could result from failure to follow the safety rules listed below.

DANGER

CAUTION

Reg. U.S. Pat. & TM. Off.
Select-Cycle is a registered trademark of Racine Federated.