WycoTool Single and Double Powerhead - Manual (Page 6)

Page 6 Form: 01-SCR-UM-00442 Rev 6/12
POWER UNIT ASSEMBLY
PRE-ASSEMBLY
1. Check box to make sure all parts were received
and undamaged.
COMPONENTS IN SHIPPING CONTAINER
2. The tools you will require for assembly are:
(1) 7⁄16” Open or box end wrench
(1) 11⁄16” Open or box end wrench
(1) #2 Flathead screwdriver
(1) Slip joint pliers
REQUIRED TOOLS
FINAL ASSEMBLY
HANDLE ASSEMBLY
Remove the handles from their shipping position
by removing the two top 7⁄16” nuts, the quick re-
lease levers and the top handle cap.
HANDLE PLATE POSITIONING
Insert the bottom of the handles into the back of
the handle plate and replace the top handle cap
over the handle. Thread on the two top 7⁄16” nuts.
Then install the quick release levers on the top of
each bracket. Placing the black hand levers in the
lower position will result in handlebar movement.
With the lever in the open position thread it
through the cap, handle plate and quick release
nut, continue threading until tight. When hand
tight place the handles at the appropriate height
and close the lever.
Add the upper handle sections to the lower handle
section and secure with the two 5⁄16” fasteners sup-
plied.