WEN 56405 Power Pro 4050 Watt - Manual (Page 23)

STOPPING THE GENERATOR
Procedure to Stop Generator
NOTE: Stopping the motor or unplugging cords from the generator while it is supplying power
to devices will possibly damage the voltage regulator and result in low or no power output until the
voltage regulator is replaced.
Following the stopping procedure will minimize the possibility of damaged voltage regulators.
1. Turn off all electrical devices being powered by generator prior to unplugging them from
the generator.
2. Turn the engine switch to the off position.
3. Turn the fuel valve to the off (horizontal) position.
Stopping when generator is to be stored for long period of time:
1. Turn off all electrical devices being powered by generator prior to unplugging them from
the generator.
2. Turn the fuel valve to the off (horizontal) position. Allow engine to run until it stops.
3. If generator will be stored for more than 60 days, remove all fuel from the tank. Fuel
removal is best accomplished by siphoning as much as is possible from the tank and then
remove the fuel hose from the fuel cock, turn on the fuel valve and drain the remaining fuel
from the tank.
WARNING:
Allow the generator to cool for several minutes before touching
areas that become hot during use.
CAUTION: Allowing gasoline to sit in the generator tank for long periods of time without
use can make it difficult to start the generator in the future. Never store generator for
extended periods of time with fuel in the tank.
19