WEN 56405 Power Pro 4050 Watt - Manual (Page 13)

ASSEMBLY
Step 1 – Wheel Installation
1. Blocking up the muffler side of the generator, assemble the axle to the frame.
2. Slide the wheel and washer onto the axle, with the offset of the wheel hub against the frame.
3. Secure the wheel to the axle with the cotter pin.
4. Repeat above instructions for the remaining wheel.
Step 2 –Foot Installation
1. Blocking up the engine side of the generator, assemble the rubber foot to the frame.
2. Repeat above instructions for the remaining foot.
Step 3 –Handle Installation
1. Assemble the handle to the frame (align with hole in tubing). Slide the bolt through handle,
frame and washer and secure with the nut. Tighten until handle is securely clamped to the
frame.
2. Repeat above instruction for remaining handle.
GENERATOR PREPARATION
Using the Generator for the First Time
The following section describes steps necessary to prepare the generator for use. If after
reading this section, you are unsure about how to perform any of the steps please call (800)
232-1195 M-F 8-5 CST for customer service. Failure to perform these steps properly can
damage the generator or shorten its life.
9