WEN 4210 10 inch Drill Press with Cross Hair Laser - Manual (Page 9)

9
Assembly and adjustments
Unpacking (Fig. 2)
Unpack the drill press and all its parts, and compare against the list below. Do not discard the
carton or any packaging until the drill press is completely assembled.
To protect the drill press from moisture, a protective coating has been applied to the machined
surfaces. Remove this coating with a soft cloth moistened with kerosene or WD-40®. Do not use
acetone, gasoline, or lacquer thinner to clean. Apply a coat of good paste wax to the table and
column. Wipe all parts with a clean dry cloth.
A Head/motor assembly
H Chuck key
B Column assembly I Allen wrench (2)
C Table J Hex head bolts (4)
D Base K Crank handle
E Chuck L Feed handles (3)
F Worm shaft M "AA" batteries (2)
G Lock handle