WEN 4210 10 inch Drill Press with Cross Hair Laser - Manual (Page 17)

17
Assembly and adjustments (continued)
Tilt the table (Fig. 20)
The table can be tilted from 0 to 45° to the left and right.
1. Loosen the bevel lock bolt (1) with a wrench.
2. Tilt the table (2) to the desired angle, using the bevel
scale (3) as a basic guide.
3. Re-tighten the bevel lock bolt (1).
4. To return the table to its original position, loosen the
bevel lock bolt. Realign the bevel scale (2) to the 0° setting.
5. Tighten the bevel lock bolt (1) with the wrench.
Square the table to the head (Fig. 21)
1. Insert a 3" (7.6 cm) drill bit (1) into the chuck (2) and
tighten.
2. Raise and lock the table (3) about 1" (2.5 cm) from the
end of the drill bit.
3. Place a combination square (4) on the table as shown.
The drill bit should be parallel to the straight edge of the
square.
4. If an adjustment is needed, loosen the bevel lock (5) with a wrench.
5. Square the table to the bit by tilting the table.
6. Tighten the bevel lock bolt (5) when square.