WEN 4210 10 inch Drill Press with Cross Hair Laser - Manual (Page 20)

20
Assembly and adjustments (continued)
WARNING: DO NOT STARE DIRECTLY AT THE LASER BEAM! A hazard may
exist if you deliberately stare into the beam. Please observe all safety rules as follows:

The laser shall be used and maintained in accordance with the manufacturer's instructions.

Never aim the beam at any person or an object other than the workpiece.

Do not project the laser beam into the eyes of others.

Always ensure the laser beam is aimed at a workpiece with out reflective surfaces as the laser
beam could be projected into your eyes or the eyes of others.
Laser switch (Fig. 26)
The laser switch (1) is located on the left side of the drill press housing.
Adjust the laser line (Fig. 26 and 27)
1. Place a workpiece on the table.
2. Turn the laser switch (1) to the ON position.
3. Lower the drill bit to meet the workpiece (2). The two laser
lines should cross where the drill meets the workpiece.
4. If the laser needs to be adjusted:
1. Using a 3 mm hex wrench, turn the laser adjustment
hex screws (3) counterclockwise.
2. Move the laser light housing (4) until the two lines
intersect where the drill meets the workpiece. DO NOT
stare directly at the laser lines.
5. Re-tighten the adjustment hex screws (3).