Van Air Systems E102 Elements - Manual (Page 3)

PRINTED IN THE USA © 2000 VAN AIR SYSTEMS INC. 2950 MECHANIC STREET, LAKE CITY, PA 16423 PAGE 3
FIGURE 3 TYPICAL ASSEMBLY (F102 Series)
*Insert appropriate filtration grades here; for example F102-3500-C uses
replacement element E101/102-625-C (five required).
TABLE 3 ELEMENT REPLACEMENT DATA
(F102 Series)
NUMBER OF
ELEMENTS IN
HOUSING
3
3
5
8
12
16
20
24
32
REPLACEMENT
ELEMENT
MODEL NUMBER
E101/102-500-(*)
E101/102-625-(*)
E101/102-625-(*)
E101/102-625-(*)
E101/102-625-(*)
E101/102-625-(*)
E101/102-625-(*)
E101/102-625-(*)
E101/102-625-(*)
FILTER
MODEL
F102-1500-(*)
F102-2000-(*)
F102-3500-(*)
F102-5000-(*)
F102-7500-(*)
F102-10,000-(*)
F102-12,500-(*)
F102-15,000-(*)
F102-20,000-(*)
FILTER HEAD
ELEMENT
O-RING
1/4" NPT
DRAIN PLUG
FHP-670-7.25
Close inlet and outlet shutoff valves (and open by-pass valve
if provided); or lock out all compressed air supply to filter
housing.
Completely depressurize filter before removing filter bowl.
Remove filter bowl using a spanner or strap wrench, turning
bowl counterclockwise.
Remove locknut from bottom of element and pull element down
off of seat. (See Figure 4).
Lightly grease element o-ring and slide element onto tie rod.
Thread the lock nut onto the tie rod and tighten hand tight.
Ensure body o-ring is seated inside filter head. Lightly grease
filter bowl threads and thread it into filter head. Tighten with a
spanner or strap wrench.
Tighten the drain plug then slowly open inlet and outlet shutoff
valves. Close bypass valve (if provided).
Filter is now in service.
1.
2.
3.
4.
5.
6.
7.
8.
FIGURE 4 TYPICAL ASSEMBLY (FHP-670-7.25)
FILTER
ELEMENT
LOCKNUT
TIE ROD
FILTER BOWL
*Insert appropriate filtration grades here; for example FHP-670-7.25-C
uses replacement element E101/102-500-C (one required).
NUMBER OF
ELEMENTS IN
HOUSING
1
REPLACEMENT
ELEMENT
MODEL NUMBER
E101/102-500-(*)
FILTER
MODEL
FHP-670-7.25-(*)
BODY O-RING