Van Air Systems ID35 User Manual
In-line desiccant dryer
PAGE 1
WARNING
DO NOT REMOVE, REPAIR, OR REPLACE ANY ITEM ON THE DRYER WHILE IT IS PRESSURIZED. DEPRESSURIZE THE
DRYER COMPLETELY BEFORE STARTING INSTALLATION AND/OR MAINTENANCE PROCEDURES. SERIOUS
PERSONAL INJURY MAY RESULT IF THESE SAFETY RULES ARE NOT FOLLOWED.
DO NOT OPERATE THIS PRESSURE VESSEL ABOVE MAXIMUM WORKING PRESSURE (MWP) AND/OR MAXIMUM
OPERATING TEMPERATURE (
O
F) AS SHOWN ON THE ASME DATA PLATE.
THIS ASME CODE VESSEL MUST BE PROTECTED BY A PRESSURE RELIEF VALVE. Refer to OSHA 1910.169 Par.
b, Sub. Par (3) and ASME Boiler and Pressure Vessel Code, Section VIII, Division 1, UG-125 through UG-136. Also
comply with all applicable state and local codes.
DO NOT WELD, GRIND, OR SAND VESSEL, OR IT WILL NOT BE SAFE TO OPERATE. (Note: Any alteration to the
vessel will void the ASME Code Certification and the warranty.)
INSPECT OUTSIDE AND INSIDE OF VESSEL REGULARLY FOR CORROSION AND DAMAGE (I.E., DENTS GOUGES
OR BULGES). ANY DAMAGE TO THE VESSEL CAN MAKE IT SAFE TO USE. IF DAMAGED, TAKE OUT OF SERVICE
IMMEDIATELY.
USE THE PROPER SAFETY RULES FOR THE GAS BEING PROCESSED.
DO NOT REMOVE THE FILL PORT UNTIL ALL PRESSURE IS OUT OF THE VESSEL.
September 2009
P/N 32-0288-B
INSTALLATION & OPERATION INSTRUCTIONS
FOR
COMPRESSED AIR/GAS
IN-LINE DESICCANT DRYER
MODEL
ID-35 (P/N 80-1364)