Triton FT7000XP Installation Manual - Manual (Page 54)

54
C
ONNECTING
AC P
OWER AND
E
THERNET
C
ABLE
5. Open the top right rear service door. Power up the units Uninterrupted Power Supply (UPS),
Power Supply, and Computer.
POWER SUPPLY CORD
SPECIFICATIONS
For European applications, the power sup-
ply cord must conform to the following speci-
fications:
1. Two-conductor with physical earth
ground.
2. IEC 320 molded connector on one end
and molded plug on the other end.
3. Certified for country of installation.
4. Rated minimum H05VV-F with minimum
0.75 mm2 (except where specific
countries require 1.0 mm2) conductors.
5. Maximum length: 3 meters.
POWER OUTLET
ACCESSIBILITY
Whether you are installing a new outlet, or
plan to use an existing outlet to supply power
to the ATM, make sure the following require-
ments are met:
1. The outlet is located near the cabinet.
2. The outlet is easily accessible.
3. Access to the outlet will not be blocked
once the cabinet is installed!
*** WARNING***
This unit is equipped with more than one power
cord. DISCONNECT ALL POWER CORDS
PRIOR TO SERVICING!
Power supply
UPS
Computer