Triton FT7000XP Installation Manual - Manual (Page 53)

53
C
ONNECT
P
OWER
/ C
OMMUNICATION
C
ABLES
FT7000 XP - S
ITE
P
REPARATION AND
I
NSTALLATION
G
UIDE
3. Plug the AC power plug into the wall outlet.
2. Route the AC power cord and the Ethernet (CAT-5) cable
through the cable access hole shown in figure at right.
1. Open the lower right rear cabinet door (2-door) or lower cabinet
door (1-door).
4. Plug the Ethernet (CAT-5) cable into the wall mounted jack.
* IMPORTANT NOTICE *
This unit is shipped with an Uninterrupted Power Supply (UPS). For safety precautions, the back-
up battery installed in the UPS has been disconnected. Before applying power to the unit, follow
the procedures below:

Remove the battery cover by pushing the cover to the left (Figure 1).

Connect the two (2) grey plugs (Figure 2).
 Reinstall the battery cover.

Once the unit is powered up, verify the “Replace Battery” indicator is OFF and the “On Line”
indicator is ON the UPS.
* IMPORTANT *
AC power for the terminal should
come from a dedicated source with
an isolated ground.
Figure 1 Figure 2