Triton MAKO PEDESTAL Installation Manual - Manual (Page 6)

6
TRITON SYSTEMS, INC.
MAKO CASH DISPENSER PEDESTAL INSTALLATION GUIDE
Place the stack of chain-mounting plates into position
for mounting. Align the corner holes of the stack with
the mounting holes you previously drilled. Place a
mounting stake through each corner hole. Each stake
should pass completely through the plate stack and fit
into the mounting hole. (Figure 11)
Hammer the stakes into the flooring (See Figure 12).
Bunch the chain into a bundle around the plate (this will
make it easier to place the pedestal into its final mount-
ing position).
INSTALL THE PEDESTAL
Place the four provided 3/4" expansion inserts into the
pedestal mounting holes that were drilled previously.
The threaded end of each insert should be inserted first.
If necessary, tap the inserts into the holes with a ham-
mer (not provided) to ensure they are flush with the sur-
face of the floor.
Move the pedestal back into position for mounting. It
may be necessary to tilt the unit slightly to clear the
security chain. Align the mounting-hole cutouts in the
pedestal base with the mounting holes.
Insert a 3/8" security bolt through a provided washer
and into each insert. Using a 5/16" socket and wrench
(not provided) and the special “pin-in-torx” bit (provided),
firmly tighten the bolts into the inserts to secure the ped-
estal to the floor.
Locate the unit’s phone and power cables in the pedes-
tal base and route the cables through the “mouse” hole
cutout in the base.
Fig. 12
6