Triton 9100 Electronic Lock Installation Manual - Manual (Page 8)

T RITON S YSTEMS
E
LECTRONIC
L
OCK
I
NSTALLATION
M
ODEL
9100 C
ASH
D
ISPENSER
8
Bad Battery/Battery Replacement
If the lock beeps repeatedly while open, or beeps twice
and refuses to open, the 9-volt battery, located in the
battery box on the inside of the door, is weak or dead
and needs to be replaced.
IMPORTANT
If the lock will not operate (i.e. no signal from
the panel when a button is pressed) while the
door is closed and locked, the battery is dead
and the lock must be energized from the two
external terminals on the front, right side of the
push-button panel.
To energize the lock, connect a 9-volt battery
across the external terminals with the negative
terminal of the battery facing up. Continue to
hold the battery against the terminals as you
enter the combination and open the lock.
Follow these steps to replace a battery:
1. Unlock and open the ATM vault door.
2. Pull gently on the front cover of the battery box and
slide the cover off.
3. Remove the old battery. Install a new battery and
replace the front cover.
4. TEST THE OPERATION OF THE LOCK BEFORE
CLOSING THE DOOR! Refer to Step 12 of the pro-
cedure on Page 6 for instructions on testing the lock.
When directed to enter the combination, use the
current combinatio!
5. Close and lock the ATM vault door.
IMPORTANT!!
BEFORE CLOSING THE CABINET DOOR,
LIFT UP ON THE DOOR HANDLE TO ALLOW
THE LOCK BAR LATCH TO ENGAGE.