9100 c – Triton 9100 Electronic Lock Installation Manual User Manual
Page 6
T
RITON
S
YSTEMS
E
LECTRONIC
L
OCK
I
NSTALLATION
M
ODEL
9100 C
ASH
D
ISPENSER
6
9.
Plug the end of the battery cable lead into the lower
receptacle on the lock marked BAT.
10. Attach two tye wrap clips on to the rear of the door
as shown. Loop up the excess cables and attach
them in place to the clips using two tye wraps.
11. Place the lock bracket back onto the back of the
lock and attach using the 1/4-inch bolt. If there is
a label on the back of the lock bracket warning the
user about proper combination settings, remove the
label. The label only applies to mechanical locks.
12. TEST THE LOCK THOROUGHLY BEFORE
CLOSING THE DOOR! To do this, lift up on the
door handle (to releave pressure on the latch
mechanism), then push down on the latch lever to
disengage the catch that holds the lock bar in the
raised position. Use the door handle to carefully
lower the lock bar to its rest (locked) position.
Next, turn the lock keypad counterclockwise to the
locked position. Try to lift the door handle; the handle
should not move. Enter 1-2-3-4-5-6 into the keypad
and then turn the lock keypad clockwise to unlock
the lock. Lift up on the door handle to raise the lock
bar. The latch catch should snap into position
underneath the lock bar to hold it in the raised
(unlocked) position. Release the door handle.
13. It is recommended that you repeat the previous step
three times to verify the lock is operating properly.
14. See the next section for details on entering and
changing the combination and replacing a dead/bad
battery.
Figure 10. Plug Battery cable into BAT
connector on lock.
Figure 11. Loop excess lengths of
cables and secure in place using tye
wrap clips and tye wraps.
Figure 12. Attach lock bracket using 1/
4-inch bolt.
BAT Connector
Cable Clips
Lock bracket back
IMPORTANT!!
BEFORE CLOSING THE CABINET DOOR,
LIFT UP ON THE DOOR HANDLE TO ALLOW
THE LOCK BAR LATCH TO ENGAGE.
Figure 13. Push down on latch lever to
open catch and allow lock bar to lower
into locked position.
Latch Lever