Triton RL2000 Installation Manual - Manual (Page 27)

2 7
M
ODEL
RL2000 I
NSTALLATION
M
ANUAL
POWER SUPPLY CORD -
SPECIFICATIONS
For European applications, the power
supply cord must conform to the fol-
lowing specifications:
1. Two-conductor with Physical
Earth (PE) ground.
2. IEC 320 molded connector on
one end and molded plug on the
other end.
3. Certified for country of
installation.
4. Rated minimum H05VV-F with
minimum 0.75 mm2 (except where
specific countries require 1.0
mm2) conductors.
5. Maximum length: 3 meters.
Power Outlet Accessibility
Whether you are installing a new AC socket outlet or plan to use an existing
outlet to supply power to the ATM, make sure the following requirements are
met:
1. The outlet is located near the equipment.
2. AC power for the terminal should come from a dedicated source with an
isolated ground. The ATM is designed to work on an IT (Isolated-Terra)
type power system having a phase-to-phase voltage not exceeding 240
volts.
3. The outlet is easily accessible and will not be blocked once the equip-
ment is installed.