Triton RL23XX/RL5XXX (XS/X2/XP) - Manual (Page 3)

d
irect
l
iGhtinG
(dc-p
owered
)
3
4. Feed the topper DC power cord through the large access hole in the cabinet.
With the topper mounting studs inserted into the four (4) corresponding
holes, place the assembly on top of the cabinet.
Note: Because of the slotted configuration of the mounting holes, there will
be some play (front-to-back) in the position of the topper assembly. Allow the
assembly to slide back until it stops.
These procedures are completed with the terminal AC power OFF.
1. Remove the topper assembly from the shipping container.
2. Locate and remove the dome plugs (if applicable) to uncover the topper
power cable access and mounting holes on the top of the ATM cabinet,
M
idtopper
i
nstallation
p
rocedure
3. Unlock and open the ATM control panel.
Figure 1. Location of topper access and
mounting holes.
Mounting Holes
Power Cord Access
Figure 3. Place nuts on topper mounting
studs and tighten down.
Figure 4. Connect the topper power
cable to the DC power supply.
5. To secure the topper assembly to the cabinet, place and tighten #8-32 nuts
on the four (4) mounting studs with a 3/8” nut driver. Plug the topper power
cable into any available 8-pin connector on the DC power supply.
Figure 2. Feed topper power cable
through cabinet access hole.