Triton RL23XX/RL5XXX (XS/X2/XP) - Manual (Page 2)

M
idtopper
F
ield
i
nstallation
G
uide
2
97XX Units!
Model 81XX, 91XX (including X2), RL16XX, RL23XX, RL5XXX
(XS/X2/XP) and most 97XX cabinets have topper mounting and access holes
in the top of the cabinet, consisting of four (4) small mounting holes and one
large access hole for internally routing the topper power cable.
Some early-model 97XX ATM cabinets do not possess a topper power cable
access hole; some cabinets have neither power cable access or mounting
holes: It is possible to cut holes in the cabinet to allow power cable access
and/or topper mounting, but such actions are to be undertaken at your own
risk! Triton Systems will accept no liability for damage that may occur to
the ATM and/or topper assembly in such cases.
iMportant notice
Triton Systems has discontinued offering a ballast/bulb (AC-powered) for
all lighted toppers. The Direct Lighting (DC-powered) Midtopper is a direct
replacement for both the ballast/bulb (AC-powered) and LED Light Panel
(DC-powered) versions. The Direct Lighting (DC-powered) Midtopper will
be the only available option.
The Direct Lighting (DC-powered) Midtopper is considered a complete
assembly with no serviceable parts. Any current model 91XX field
installations that still use the original hard-wired single power supply will
require the power extension cable (included in the kit).
The Direct Lighting Midtopper can be identified by the raised back panel,
versus the flat back panel indicative of the AC ballast/bulb and the DC LED
Light Panel versions.
This manual will show the physical installation of the topper as well as the
individual DC power connection.
NOTE
Although the initial figures in this procedure depict a 91XX
cabinet (with a vertically mounted dual power supply),
the installation instructions are applicable to 81XX,
97XX, RL16XX, RL23XX, and RL5XXX (XS/X2/XP)
cabinets as well. The actual physical case characteristics
and mounting position of the DC power supply will vary
by model type. Any significant differences will be noted
in the DC Connections section as applicable.