Spectra Precision Survey Pro v4.6 GPS - Manual (Page 6)

4
Data Modem
For RTK base, RTK rover, and Ntrip rover receivers, you
must choose a data modem type and configure the
communication settings between the receiver and the modem
hardware. The choices of data modem will be different for
base and rover, and will vary between brands. If your specific
modem hardware is not listed in the interface, you can choose
Generic Serial
and set the baud rate and parity for the
receiver to send data to the modem device.
General Settings
This card is used to pick brand and model specific settings.
The settings on this page will depend on the receiver model.
For more information, see the Reference Manual.
Post Process Settings
The Job | Settings | Post Process card is used to set the
recording interval for logging GPS data for post processing. If
you wish to setup logging of raw GPS data for post processing,
either simultaneously with RTK data collection or for post
processing only data collection, go to the Post Process settings
card and select a Recording Interval.
RTK Data Collection and Stake Out
This section describes:
¾ How to start RTK data collection using the Start GPS
Survey wizard.
¾ How to setup receiver logging for post processing data
collection simultaneous with RTK.
¾ How and when to collect control points to solve a
localization coordinate system adjustment.
¾ How to use the different data collection functions
¾ How to use the different stake out functions
¾ How to select a map projection zone and how to setup a
Ground Coordinate system.