Spectra Precision Survey Pro v4.6 GPS - Manual (Page 18)

16
Session screen is opened. Tap Apply to write the information
to the post processing file. You can remain connected to the
receiver to monitor the entire session, or you can leave it to
log the data file unattended. If you start a stop and go file,
the Static Receiver Session screen is opened for post
processing data collection as described below.
If the connected receiver is already recording data, you can
tap Stop Recording to end logging.
Post Processing Data Collection
After recording is started, the Static Receiver Session screen
is opened. You can also access this screen by going to the
Survey | Data Collection menu and choose to connect to a
post processing receiver. Use the following controls for post
processing data collection:
Store Point In:
¾ Receiver and job file will mark the event in the post
processing logging file, and store a point in the Survey
Pro job. You can use this mode to save attribute or
layer information in the Survey Pro job file.
¾ Receiver
file only
will only mark the event in the post
processing logging file. In this mode, the Site ID does
not need to be a unique point name, and nothing is
stored in the Survey Pro job file. A note record is
made for this occupation in the Survey Pro raw file.
NOTE: By default, post processing points are stored in the
Survey Pro job file are put on a special layer to distinguish
them from other data collected points. Points stored in
Survey Pro job file will have a plane coordinate of (0,0,0) and
a geodetic coordinate from the receiver’s autonomous position.
Session Duration:
¾ Enter 0 or check Log Until Stop to have this session
run until you tap Stop.
¾ Enter the session time if you want Survey Pro to
mark the end of the session automatically after the
timed interval has elapsed.