Auto-test at start-up, Installing a firmware upgrade, English – Spectra Precision ProMark 700 User Guide User Manual
Page 14
English
10
Auto-Test at Start-up
Auto-test is performed during the receiver start-up sequence
to check internal communication ports, including Bluetooth.
Should a problem be detected during the auto-test, the
Power/Charging LED will turn solid red -instead of the normal
solid green- at the end of the start-up sequence. In that case,
you should reset the receiver as explained in this manual (see
above). If the error still persists after a reset, please contact
Technical Support.
Installing a
Firmware Upgrade
In the future, Spectra Precision may provide a maintenance
file (a *.bin file) should the ProMark 700 firmware need to be
upgraded.
In that case, please use Spectra Precision’s ProMark 700
Loader software utility to install the firmware upgrade.
This utility can be downloaded from:
(Then click on the Support tab)
ProMark 700 Loader should be installed on a computer fitted
with a USB or RS232 port, or having Bluetooth capability.
Follow the instructions below to upgrade your ProMark 700:
• Set up ProMark 700 according to one of the diagrams
below (see also Optional Accessories on page 2 for the
serial setup).
1) Bluetooth
2) Serial Cable
Universal AC/DC
adapter cable (to power line), or
vehicle power cable (to external battery)
Bluetooth
Power cable
extension
Universal AC/DC
adapter cable (to power line), or
vehicle power cable (to external battery)
Cable kit P/N 91865-00
DB9
USB