SHARKOON Bandit - Manual (Page 9)

bandit
9. installation of an additional 3.5" device
(1. Remove the case’s front panel by gently dragging it towards you (fig. 19.)
fig. 19
2. Dismantle the 5.25" front bezel from the mounting bay in which you intend
to install the drive by loosening its screws and pushing the bezel to the
inside (fig. 20). Remove the quick fasteners (fig. 21).
fig. 20 fig. 21
(Carefully take out an optionally present metal bezel covering the drive bay
by using a gripper.)
3. Place the 3.5" device into the mounting frame for 3.5" devices and screw it to
the mounting frame from both sides (fig. 22).
(Mounting frame for 3.5" devices)
fig. 22
4. Slide the mounting frame with installed 3.5" device into the case’s drive bay
(fig. 23) and attach it to the drive bay from both sides using the quick
fasteners for ODDs (fig. 24).
fig. 23 fig. 24
Note:
If you intend to transport the case we recommend securing (additionally) the
installed drives.