SHARKOON Bandit - Manual (Page 8)

bandit
8. installation of an optical device
(1. Remove the case’s front panel by gently dragging it towards you (fig. 14).)
fig. 14
2. Dismantle the 5.25" front bezel from the mounting bay in which you intend
to install the drive by loosening its screws and pushing the bezel to the
inside (fig. 15). Remove the quick fasteners (fig. 16).
fig. 15 fig. 16
(Carefully take out an optionally present metal bezel covering the 3.5" drive
bay by using a gripper.)
3. Slide the optical drive into the case’s drive bay (fig. 17).
fig. 17
4. Attach the optical device from both sides using the quick fasteners (fig. 18).
fig. 18
Note:
If you intend to transport the case we recommend securing (additionally) the
installed drives:
(Screws for 5.25" drive mounting)
5. Connect the optical drive to the power supply and the mainboard.
(Put the front bezel back onto the case.)