SHARKOON Bandit - Manual (Page 6)

bandit
6. Plug the connectors of the case’s front bezel to the respective connectors of
the mainboard (also refer to your mainboard’s manual for further information).
Note:
The eSATA cable connected to the front eSATA connection should not exceed
50 cm of length otherwise transmission errors may occur! With premium
quality eSATA cables this maximum length may be exceeded.
6. installation of a PSu
1. Set up the case in front of you and put the PSU from the inside against the
PSU bracket on the case’s back side (fig. 5).
fig. 5
2. Screw the PSU to the case from the outside (fig. 6).
(Screws for PSU mounting)
fig. 6
7. installation of a Hdd
1. Remove the case’s right side panel.
2. Remove the front bezel’s fixation screws on both sides (fig. 7).
fig. 7
3. Remove the case’s front panel by gently dragging it towards you (fig. 8).
fig. 8