Seca 657 - Manual (Page 34)

34
6. Storing the scale
The scale can be stored upright to save space. Secure the scale so that it does not fall
over when stored in the upright position.
– Remove the mains unit plug from the
mains socket.
– Remove the mains unit plug from the
connecting socket on the scale.
– Press the locking mechanism on the
Western plug and remove the plug from
the socket on the electronics box.
– Fold up the ramps.
– Carefully pick up the scale by the han-
dles and move it using the castors on
the other side of the scale. When mov-
ing the scale, always hold it firmly in
both hands.
The scale is easy to steer by the centre
castor.
7. Cleaning
Clean the rubber surface and the housing as required using a domestic cleaning agent or
commercially-available disinfectant. Follow the manufacturer’s instructions.
Under no circumstances use abrasive or acid cleaners, white spirit, benzene or the like for
cleaning. Such substances can damage the high-quality surfaces.
8. What do I do if…
… no weight display comes on?
– Is the scale switched on?
– Is the plug contact of the mains unit properly connected to the scale?
– Is the plug contact for connecting the display to the scale correctly connected?
…
0.0 does not appear before weighing?
– Press the Start key again – there must not be any load on the scale – and only its feet
should be in contact with the floor.