Seca 757 - Manual (Page 68)

68 •
Setting the display
backlighting (Lcd)
You can change the duration and brightness of the
display backlighting.
1. Select the “Lcd” item from the menu.
2. Confirm the selection.
3. Select a menu item
– dUr: duration
– bri: brightness
4. Confirm your selection.
The current setting is displayed.
5. Select the setting you require:
6. Confirm your selection.
You exit the menu automatically.
7. If you also wish to make settings for the second
function, repeat this process.
Restoring factory
settings (RESET)
You can restore the factory settings for the following
functions:
NOTE
The wireless module is switched off when fac-
tory settings are restored. Information about
existing wireless groups is retained. Wireless
groups do not have to be set up again.
1. Select the “rESEt” item from the menu.
2. Confirm the selection.
You exit the menu automatically.
Function Setting
Duration
• Short (approx. 15 sec.)
• Long (approx. 45 sec.)
• PErM (continuous)
Brightness
• 50 %
• 100 %
• Off
Function Factory setting
Autohold (AhoLd)
depending on
model
Acoustic signal (PrESS) Off
Acoustic signal (HoLd) On
Attenuation (FiL) 1
Wireless module (SYS) Off
Autosend (ASEnd) Off
Autoprint (APrt) Off