SANDPIPER M05 Non-Metallic - Manual (Page 13)

m05nmdl2sm-rev0114 Model M05 Non-Metallic Page 11
476-219-000 aIr enD kIT
Seals, O-ring, Gaskets, Retaining Rings, Air Valve
Assembly and Pilot Valve Assembly
476-220-000 aIr enD kIT (Air Valve with Stroke Indicator Pin)
Seals, O-ring, Gaskets, Retaining Rings, Air Valve
Assembly Pilot Valve Assembly
476-202-360 WeT enD kIT
Nitrile Diaphragms, Nitrile Check Balls, PTFE
Seats and PTFE Seals
476-202-365 WeT enD kIT
Neoprene Diaphragms, Neoprene Check Balls,
PTFE Seats and PTFE Seals
476-202-354 WeT enD kIT
Santoprene Diaphragms, Nitrile Spacer Gaskets,
Santoprene Check Balls, PTFE Seats and
PTFE Seals
476-202-357 WeT enD kIT
Polyurethane Diaphragms, Nitrile Spacer Gaskets,
Santoprene Check Balls, PTFE Seats and PTFE Seals
476-202-654 WeT enD kIT
Santoprene Diaphragms, PTFE Overlay
Diaphragm, PTFE Check Balls, PTFE Seats
and PTFE Seals
476-202-659 WeTTeD enD kIT
One-Piece Bonded PTFE/Nitrile Diaphragm,
PTFE Balls, PTFE Seats
DIAPHRAGM CONFIGURATION
DETAIL
NOTE TO ASSEMBLY
THE DIAPHRAGMS FOR BOTH
CONFIGURATIONS SHOWN ABOVE ARE TO BE
INSTALLED WITH CONVOLUTIONS FACING
TOWARDS CENTER OF PUMP
ImPorTanT noTe: Polypropylene pumps are shipped with the 1/2" NPT Pipe Plug (Item 37) installed in the end ports of both suction and discharge one-piece manifolds. To convert to the Inline porting
positions for pump installation and operation, first remove the pipe plugs and re-install in the center ports. Apply PTFE tape or pipe sealant to threads of the plug before installation.
Composite repair Parts Drawing
available service and Conversion kits
13
22
1
12
13
32
29
26
7
30
31
6
28
19
15
27
14
2
34
25
9
17
33
10
33
10
27
16
15
5
25
11
34
2
18
10
9
33 10
33
10
25
25
21
3
20
8
12
***MUFFLER OPTION *OVERLAY OPTION
24
10
23
25
25
4
23
INLINE SUCTION
MANIFOLD OPTION
37
35
INLINE DISCHARGE
MANIFOLD OPTION
36
37