RIKON Power Tools 50-142 - Manual (Page 6)

6
The sander must not be plugged in and the power switch must be in the OFF position
until assembly is complete.
Getting to Know Your Sander
Assembly
Item Description
A. Sanding Belt 1” x 42”
B. Sanding Belt Tracking Knob
C. Sanding Disc 8”
D. Miter Gauge
E. Disc Table
F. V-Belt Safety Cover
G. Sanding Belt Safety Cover
H. Sanding Belt Dust Port
Item Description
I. Motor
J. Disc Table Angle Scale
K. Disc Table Lock Handle
L. Disc Dust Port
M. ON/OFF Switch with Disabling Key
N. Rubber Machine Feet
O. Sanding Belt Table Lock Handle
P. Sanding Belt Table
Unpacking and Clean-up
1. Carefully finish removing all contents from shipping carton. Compare contents of the
shipping carton with the list of contents above. Place parts on a protected surface.
2. Report any shipping damage to your local distributor.
3. Clean all rust protected surfaces. Do not use; gasoline, paint thinner, mineral spirits,
etc. These may damage painted surfaces.
4. Set packing material and shipping carton to the side. Do not discard until machine
has been set up and is running properly.
A
B
D
E
L
M
N O
P
F
G
H
I J
K
C