RIKON Power Tools 10-201 - Manual (Page 9)

A
Fig.7
B
Fig.8
Fig.9
2. Install the belt on the Arbor Pulley and raise motor
by loosing 1 of the motor mounting screws (B) to
reach the belt distance for assembling the belt on
the motor Pulley. SEE FIG.8 & FIG.9
3. Replace the cabinet access door.
9
EXTENSION WING ASSEMBLY
CAUTION: The extension wing is heavy; two people are
required for assemble. The installation method for
granite and cast iron wing is the same.
1.One person put right/left extension wing on the top of
cabinet. Alignment pin into bottom of wing (A).
SEE FIG.10
1.One person put right/left extension wing on the top of
cabinet. Alignment pin into bottom of wing (A).
SEE FIG.10
Fig.10
2. Another person locks 4 bolts (B) with flat and spring
washer and from the bottom of cabinet and tighten it.
SEE FIG. 10
2. Anothe Another perso person lock locks 4 bolt bolts (B (B) wit with fla flat an and spring spring
washe washer an and fro from th the botto bottom of cabine cabinet an and tighte tighten it. it.
SE SEE FIG FIG. 10 10
NOTE: Step1 and step2 can complete
the assembly for extension wings easily.
Need not adjust the flatness for
extension wings after assembling.
Because we have done the pre-
adjustment and pre-setting of the
extension wings for the flatness in
factory.
Nee Need no not adjus adjust th the flatnes flatness for for
extensio extension wing wings afte after assembling. assembling.
Becaus Because we hav have don done th the pre- pre-
adjustmen adjustment an and pre-settin pre-setting of the the
extensio extension wing wings fo for th the flatnes flatness in in
factor factory.
A
B