RIKON Power Tools 10-201 User Manual
Page 10

10
3. The user can adjust the flatness for the extension
Wings to obtain more flatness. We suggest that user
need not do this adjustment again, the process are as
following if user want to do the adjustment again.
4.To loose 4 screws (B) by 6.0mm Allen Wrench;
5.To loose 4 setting screws (C) by 2.5mm Allen wrench.
SEE FIG.12
3. The user can adjust the flatness for the extension
Wings to obtain more flatness. We suggest that user
need not do this adjustment again, the process are as
following if user want to do the adjustment again.
Fig.12
6.
E
Using an open wrench to adjust the 4 elevation
screws ( ) to raise or lower the extension wing to the
table. SEE FIG.13
Fig.13
7.Use a straight edge across to the main table and
extension wings, checking the flatness of both main and
extension wings. SEE FIG.14
Fig.14
8. Make sure both wings are aligned, if not, refer to step
(6) until completely adjusted.
9. Using a 6.0mm Allen wrench to secure 4 screws (B).
C
E
- 10-305 (24 pages)
- 10-308 (20 pages)
- 10-315 (28 pages)
- 10-321 (52 pages)
- 10-325 (28 pages)
- 10-346 (38 pages)
- 10-350 (32 pages)
- 10-370 (34 pages)
- 10-600VS (17 pages)
- 23-400 (22 pages)
- 23-400H (28 pages)
- 25-010 (26 pages)
- 25-010H (32 pages)
- 25-200 (26 pages)
- 25-200H (36 pages)
- 30-100 (24 pages)
- 30-120 (20 pages)
- 30-140 (21 pages)
- 30-240 (22 pages)
- 30-251 (21 pages)
- 34-250 (18 pages)
- 50-112 (18 pages)
- 50-120 (18 pages)
- 50-142 (24 pages)
- 50-150 (18 pages)
- 51-200 (14 pages)
- 60-100 (16 pages)
- 60-200 (16 pages)
- 61-200 (16 pages)
- 61-1250 (18 pages)
- 61-1600 (18 pages)
- 61-2400 (18 pages)
- 62-100 (16 pages)
- 63-100 (16 pages)
- 70-050 (16 pages)
- 70-100 (18 pages)
- 70-300 (28 pages)
- 70-425 (18 pages)
- 70-500 (28 pages)
- 80-805 (22 pages)
- 10-110 (27 pages)
- 10-300 (17 pages)
- 10-320 (22 pages)
- 10-340 (22 pages)