RIKON Power Tools 10-201 User Manual

Page 7

• The table saw is a heavy machine; two people may be

required for certain assembly operations.

• DO NOT assemble the table saw until you are sure the

tool is unplugged.

• DO NOT assemble the table saw until you are sure the

power switch is in the "OFF" position.

• For your own safety, DO NOT connect the machine to

the power source until the machine is completely
assembled and you read and understand this entire
User Manual.

INSTALLATION AND LEVELING

Final location for the saw must be level, dry, well lighted,
and have enough room to allow movement around the
saw with long pieces of wood stock.

Level the saw front to back and side to side. If necessary,
but make sure the saw is stable before being placed in to
service.

CABINET LEG ASSEMBLY

Fig. 1

1. Attach leg assemblies (A) to the right (J) and left (k)

of the table saw cabinet by placing (B) eight
M8X16mm carriage screws through the mounting
holes and place an M8 flat washer, M8 lock washer
and M8 hex nut onto each of the eight screws
attaching leg assembly to cabinet. Do not completely
tighten hardware at this time.

2. Attach two tie bars(C) and (H) between right and left

legs inside and tighten them with D) eight

and

3. Attach middle bar (E) between tie bar (H) and (C)

inside, using four

(

M8X16mm

carriage screws M8 flat washer

M8 lock washer

M8 hex nut

M8X16mm carriage screws M8 flat

washers

M8 lock washers and M8 hex nuts to tighten

it.

4. To tighten the legs (A) and tie bar (C) by two (L)

M8x45mm hex soc head screws, M8 flat washers, M8
lock washers;

5. Attach Mobile base caster assembly (I) to the tie bar

(H) and using two M8X16mm carriage screws and M8
flange hex nuts to tighten it.

6. Place two leveling screws (G) to the lags (A) and

place an M8 flat washer, M8 lock washer and M8 hex
nut onto each of the two screws and tighten them.

7. Attach two caster wheels(F) to the tie bar(C) and

place two M8x55mm hex soc head screws through the
mounting holes of the bar and wheels, and using M8
lock nut to ighten them.

SEE FIG.1

1. Turn the table saw side lay.

The table saw

is heavy; two people are required for this operation. Be
sure to lay cardboard on the floor to protect the table
and cabinet.

CAUTION:

Fig.2

7. To align the hole of cabinet with the hole of cabinet

leg, and using eight M8x20mm hex head screws, M8

flat washers M8 lock washers and M8 hex nuts to
tighten them.

SEE FIG.2 & FIG.3