Rhino Shelter DOMED-40W X 60L X 18H - Manual (Page 8)

#5) are secured inside of the arch assemblies.
Note: Cross Rails (Purlin Horizontal Tubes) (Part
using M10x85 carriage bolts (Part #28A) and nuts.
M10x75 bolt through base Plate and sidewall tube to
from popping out of the socket while assembly continues.
base Plate, insert a M10x75 bolt(29) and nut to prevent it
Assembly Instructions 40x60x18 Domed Style Truss Building
8
Version 3.1
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
ERECTING ARCHES
Step#4 – Combining Arches Into Frame
Begin frame assembly by erecting Front Arch into Front
Corner Base Plates. Place left frame sidewall tubing into
In order to insert Right Sidewall Tube into Right Front
Corner Plate (Part #6R), it is necessary to support arch
on left side to prevent movement. Position the Right
Sidewall Tube over the Right Corner Base Plate.
Figure 9
Once the Right Sidewall Tube is placed into right corner
Next stand first interior arch (#2 or #6) up to repeat
insertion into Base Plates. Place left sidewall tube into
the upright socket of first interior Base Plate. Put
secure in place.
Supporting the left side of the arch, put the arch
assembly right sidewall tube into the right side Base
Plate upright socket.
Immediately after putting first interior arch into place,
connect Front Arch and Interior arch using Cross Rail
Tubes (Part #5) at top ridge and side shoulder cures of
arches. Secure the Cross Rail tubes (Part #5) into place
Figure 10
Use Carriage Bolts with Washers and Nuts through pre-
drilled holes in frame members. Refer to detail drawing
for correct hardware. Be certain to insert carriage bolts
from the outside into the interior of the unit, with the
washers and nuts on the inside of the frame. Do not
tighten down the nuts completely.
Next install the Wind Brace supports that connect the
Front Arch to the first Interior Arch (#2). Use two Wind
Brace Supports (#17) in an ‘X’ fashion between the
sidewall tubes. Use a Wind Brace Clip (#17A) at the end
of each Wind Brace support tube. The Wind Braces give
the arch assemblies strength as a unit.