Rhino Shelter DOMED-40W X 60L X 18H - Manual (Page 6)

Plate.
for the washer and nut to be tightened over the Base
Base Plate thickness and adequate thread to be exposed
Leave sufficient shaft above the ground to allow for the
wrench (Part #24A), turn the earth auger into ground.
Each Big Bear 40x60x15 building comes with
Assembly Instructions 40x60x18 Domed Style Truss Building
6
Version 3.1
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
INSTALLATION OF BASE PLATES
Using one Base Plate as a panel, mark the Earth Auger
hole through the Base Plate by pushing the Auger point
through the Base Plate hole in place. This will leave on
impression in the ground when the Base Plate is
removed. The auger tip should be started into the
ground where the depression under the hole was made.
After the hole is marked, move the Base Plate to one
side to expose the impression for the Auger. Using the
Replace the Base Plate into place, with the threaded
shaft of the auger sticking through the base hole. Re-
check the dimension from the corner or adjacent base
Plate before tightening. Tighten the nut and your
assembly will be securely fastened to the ground.
Follow the above procedures for each subsequent Base
Plates of the assembly. It is suggested that you begin
with the four corner anchors to be used as reference
points to the next base Plate. Alignment and dimensions
should be checked continually as Base Plates are
secured.
INSTALLATION OF EARTH ANCHORS
twenty two (22) EARTH CABLE ANCHORS (Part #25)
with U-bolts and nuts (Part #26). These versatile
anchors allow the frame to be secured to almost any
surface. In addition you have also been provided with a
36” Drive Rod (Part #27) used to drive the anchor heads
into the earth.
If the location where you are placing the building has
very hard ground or any rock in it, pre-drill the holes
before inserting anchors. Hammer drills can be rented
at most home improvement or rent-all centers. Hitting
the anchors into rock will cause the drive rod end to
mushroom inside the anchor head, and prevent the drive
rod from coming out of the hole.
Anchor placement should be made inside the frame.
Anchors secure the building to the ground to prevent
spread of the frame over time.