Rhino Shelter DOMED-40W X 60L X 18H User Manual
Page 17

Assembly Instructions 40x60x18 Domed Style Truss Building
MAINTENANCE & CARE
Annually or more often, the unit should be
completely inspected internally and externally to
make certain the unit remains properly installed and
secured. Particular attention should be paid to:
Hardware - check all carriage bolts and hardware
connectors to be certain they are in place and
tightened.
Base Plate Anchors - during normal weather trends,
the unit will strain against the base plate anchors
under windy conditions. Anchor hardware
connection to frame members should be maintained
tight and depth of anchors should be checked to be
certain they remain deeply and firmly set.
Snow Accumulation - All snow accumulation on the
main cover should be removed as soon as possible.
Tap the main cover from the inside with a broom or
soft brush to clear cover.
Main Cover Lacing - the poly rope that secures the main
cover to the bottom rail of the frame assembly should be
checked, and adjusted as needed. The tension on the
main cover should be uniform from end to end and side
to side. Rope ends must be tied off onto the frame
members at the ends on each side.
Cleaning - cover and doors can be cleaned with a
mixture of light detergent and water. A soft bristle brush
with the mixture can be used to loosen any hard dirt,
mold, or buildup on the cover. After cleansing, the cover
should be rinsed thoroughly to avoid any chemical
reaction from residual detergent. Allowing dirt and
debris to sit on cover over an extended time will damage
cover irreparably.
Severe Weather - in preparation for inclement weather,
completely secure the door of your
portable building. Allowing wind to enter end lifts the
17
Please DO NOT return unit to store or dealer. For all questions or shortages please contact
Customer Service at: 800-447-7079 or 203-877-7070
Single Door Pulley Farthest From Winch
Assembly
Door can now be opened or closed by
operating the Winch Assembly. Raise and
lower the door several times to be certain door
tube ends are not binding on track. Lubricate
if necessary.
Big Bear buildings
Version 3.1