Rhino Shelter ROUND-14W X 24L X 10H - Manual (Page 6)

Assembly Instructions Boat/SUV Storage 14x24x10
ANCHOR STEP 3
Slip one side of the U-bolt through the eyelet at the end
of the anchor cable. Attach the cable to the Arch leg
upright with the U-bolt and tighten. Do not attach to base
cross rails. Ensure there is no slack in the cable. Slack
can be removed by wrapping the cable around the tie-
down rail.
Assembly Instructions V2.2
Please Do NOT Return Assembly to Dealer or Store. For All Assembly Questions or Shortages Please Call MDM Products Directly
Customer Service 800-447-7079 or 203-877-7070
6
END PANEL INSTALLATION
Note: End panels MUST be installed before installing
Main Cover onto frame.
Step1. Remove Carriage bolts from the Top Crest Rail
and the two Upper Cross Rails at the End Arch
Assembly. Install End Panel Door w/Zippers #DZD-7002
one at a time to the frame assembly. Carefully align the
door material evenly over the arch to make an even fit
side to side.
Step 2. Place the end panel over the first arch and wrap
the material over the End Arch bringing the slits in the
end panel to the inside of the frame. Place the top ridge
rail pole and the side cross rail poles through the
material slits and replace the carriage bolts and tighten.
Each door end will also require removal of the wind
brace bolts and placement of the wind braces through
slits in the ends panel. Reconnect wind braces with
carriage bolts once end panel is put into place.
The tightening rope slot should be located inside the
unit, with the frame members passing through the pre-
cut slots in the end panel/door. Replace the carriage
bolts after putting the end panels into position.
Step 3. Tie off one end of the rope coming out of the
end panel to a turnbuckle (turn-buckle should be
loosened all the way) and attach the turnbuckle to the
hole in the foot of the end arch. Hold the end of the
unsecured rope and apply downward pressure with a
foot to remove excess slack. Re-adjust gathered
material evenly along inside edge of door rope slot. This
step is key to getting a good door fit. Tie off the end off
the rope to a second turnbuckle (fully opened) attached
to a hole in the foot of the end arch on the opposite side.
The end panel can then be tightened further by adjusting
each turnbuckle.
Turnbuckles
Side Cross Rails
Top Ridge Rail