Mediabridge MWN-WAPR150N User Guide User Manual
Page 17
MWN-WAPR150N Wireless Router v11.8
17
6. Power on your Medialink Router.
a. Connect the AC/DC Adapter to the router’s
Power port. Connect the other end into an
electrical outlet. Wait 10 seconds to allow
the router to fully start.
7. Check the status of your Medialink Router.
a. On the front panel of your Medialink Router,
the POWER, SYS, WLAN, and INTERNET
(WAN) LED’s should be lit or blinking. If not,
make sure the cables are connected
correctly.
8. Power ON Your Computer.
a. Turn on your computer
b. It is recommended that you temporarily turn
off any third party firewalls or networking
software during installation of your Medialink
Router.
9. Confirm Access To The Internet –
a. If your computer is wired into the router,
open your internet browser (For example,
Internet Explorer, Firefox or Safari) and