Lincoln Electric IM845 POWER WAVE 355M - Manual (Page 13)

A-6 INSTALLATION A-6
POWER WAVE ® 355M
CONFIGURING THE SYSTEM
The power source will “Auto Map” the system eliminat-
ing most of the need to set DIP switches to configure
the system.
If a system can not be “Auto Mapped” then the status
light on the power source will blink green fast and the
welder output will be disabled.
If a system is not “Auto-mappable”, then consult the
instruction manual for the accessory being used for
configuration information about DIP switch settings, or
consult your local Lincoln sales representative.
POWER WAVE
®
355M
ROBOT
PLC CONTROLLER
ANALOG INTERFACE
etc.
POWER WAVE ® 355M
POWER WAVE ®
355M
POWER WAVE ®
355M
FEED HEAD
FEED HEAD 1
CONTROL BOX
SINGLE HEAD FEEDER DUAL HEAD FEEDER
SINGLE HEAD BOOM FEEDER
PF-10R
SINGLE HEAD BOOM FEEDER
UP TO 4 WIRE FEEDERS
ALLOWED
UP TO 4 FEED HEADS
ALLOWED
WIRE
DRIVE
MODULE